Separate names with a comma.
Thanks Matt!
Matt, here's a look at my ht-8 bracing. At the moment, the woofer section at 11.5 X 9.5 inches does not have any bracing. the mdf is 1/2":...
I’m in the process of building custom boxes for my recently received HT-8 kits. They will be used as surrounds and flush-mounted in wall columns....
So I'm not a wizard at Winisd, but here's a first attempt to coax a little more bass from the Celestion. I set the tuning frequency at 65 vs 70....
Excellent. I’ll give it a go!
Matt, I just stumbled across this post and since I’m building custom cabs for my HT8 surrounds, I’m considering increasing box volume for extended...
I'm modeling a "tall" HT8 enclosure at the recommended .655 cu ft. volume to fit in my HT speaker column design. The flat packs come with 1/2 inch...
I started another thread earlier discussing my efforts to design proportional-looking columns to house the HT-8. My problem was that the supplied...
I already inquired about this at the DIYSG web site. Here's what I wrote Erich: SO Erich, after spending hours trying to keep my room column...
Matt, I was planning on building 4 VBSS subs until I stumbled across the Flex-12. Can you explain the critical differences between the 2 designs?...
Yes I saw the compression driver depth as you stated, but what about the wave guide depth as noted by Erich? Sorry about that. I didn’t...
Am I correct I’m assuming the waveguide/driver is a custom build? In other words, there’s no retail equivalent I can use as a reference for depth...
