Separate names with a comma.
Sorry for the late reply. Had forgotten about this forum for it being slow at times. Thank you for the kind words. Any two part, long cure epoxy...
It certainly opens up more options, along with the grilles on the speakers, for having searched everywhere for something I liked to no avail. I...
Final product and rid of the ghetto cardboard boxes they were sitting on prior. [img]
Then it was just a matter of sanding (I sanded most of the material before I welded it together) and using an aluminum etch primer, then a couple...
Then supported the cross stretchers flush with my aluminum level and some clamps. The little notches at the intersection is so the welds will be...
I built the Fusion-12 Tempests and the only place I have for them is atop end tables in the corners of my room. The reason I opted to leave them...
Finally finished. They sound great. [img] [img] Currently eyeing the Fusion-8 Alchemy as a possible next build. If they're anything like the...
I have been listening to these speakers for about a week. Finally took them down to do some finishing work. They are pleasant to listen to. A good...
2nd day, made the braces from plywood being they are so thin. It should help keep the sides flatter over the years. I will seal the insides with...
These are for my bedroom. Scored another Denon 3805 for $50 off Crgslist. Also have my older, but capable Dell/Linux PC to sorce it with if I...
I used 2 lbs polyfil but upholstered it in there with tulle fabric and staples. Trying to use adhesive with fuzzy stuff just seemed like something...
Box with brace installed and the primary baffle plus the hole for the binding post mount. [img] The secondary baffle routed and tacked in place...
After auditioning the Fusion-12 Tempests for awhile full range, just to see how they performed in my particular space, I settled on the Dayton...
