Separate names with a comma.
Oh, I already glue in the baffle. I will mount the crossover on the side of the woofer. I will leave the bottom half clear for the port. Based...
I see, thanks for the clearification. The included 8 small black plastic tubes are riser to use with the PCB board? I assume you can mount the...
Thank for the link Scary. Just finish with the board. But I'm not sure which wires are going within the speaker. Is HI +/- is going to the...
ThanKS a lot. For the cabinet assembly, the cut out groove is a very tight fit, need to use a rubber mellet to get into the groove, after that it...
Hi, I just received 2X flat pack Volt 10LX kits (ported) yesterday. The package is well packed. This is my first DIY speakers, I have some noob...