Separate names with a comma.
Other projects have taken priority over this one. I still plan on building them but I don't know exactly when I will get around to it.
I've previously cut some baffles designed to fit that box for another member, it was designed to use the 2.5" flared port that PE sells, the port...
They would work in the slanted Volt-6 flatpacks but obviously the stock Volt-6 baffle isn't compatible with this driver. It should also be used...
It could benefit a little from a brace placed there.
It could be interesting to try, through the f3 on these is already quite high when sealed and using the aperiodic vent to decrease the Qts would...
The 1" Walmart mattress topper should be ok, I would just make sure you line the back, sides, top and bottom. When I have cut the holes for those...
The port pointing down is not an issue if it's out of the way of the driver.
In that case also double check that you didn't mix up the woofer (LF) and midrange (MF) terminals. You can also wiggle the leads of the...
If you have a multimeter check the resistance between the positive on the input terminal block and the positive on the LF terminal block, it...
A simple ported box could be 14" wide x 12" deep x 22" high. This will give you approximately 1.55cuft gross volume. Could use a single one of...
If you just need it flat against the wall you can use one of the aluminum french cleat hangers (Hangman). Small flatscreen TV mounts also work...
Totally fine to use terminal cups, I use them on pretty much all of my builds.
I now have the PCBs for these and in case you missed it I posted the crossover information as well as the measured frequency response at the end...
The HT-8 uses the Celestion TF0818 so you can use that to model the enclosure volume.
You can use 1/2" MDF, I'd just throw some extra bracing in there. Try to leave no more then a 6-8" span unbraced. Walmart mattress topper will...
I don't have the PCB's yet as I am waiting until I verify the crossover values but will post here when they are available. I'll send you a PM for...
---
They would likely work ok with the HT8, no worse then the volts which many people use together with the HT series with good results.
Shouldn't be too much of a difference if you wanted to put the port on the side vs the front of the cabinet. The cutout is a little tricky. I...