Re: DW-774S/DNA150 + Celestion TF0818 design/build Thanks Roger, I am happy just to have contributed and without Erich none of this would have...
Looks good craig. I use this stuff for my damping material and really like it:...
I see about the same in winisd. If you have a highpass at 80hz you safe until you get well over 200 watts.
Re: DW-774S/DNA150 + Celestion TF0818 design/build Woohoo first review. :) Thanks gadkins. Really glad you like them. Placing them...
Re: MTG-06a-OWS Spayer was this one:...
Re: MTG-06a-OWS I finished painting these the other day. I only got one coat on them though beacuse I broke the spray gun. >:( Dropped it...
Re: DW-774S/DNA150 + Celestion TF0818 design/build I am pretty sure the denim is up there with fiberglass for effectiveness. Fiberglass is...
Re: DW-774S/DNA150 + Celestion TF0818 design/build Hi Roger, and thank you. The fiberglass/darcon should work fine, make sure there is an opening...
Re: MTG-06a-OWS My Paint booth setup and enclosures ready for primer. [IMG] I use Zinsser FastPrime2 which is a water based primer, I think it...
Re: DW-774S/DNA150 + Celestion TF0818 design/build Thanks guys, they still bring a smile to my face when I look at them.
Re: MTG-06a-OWS I am going into a little more detail of my finishing process on these. My first step is to fill any seems or cracks where the...
Re: DW-774S/DNA150 + Celestion TF0818 design/build I like the look of the semi-gloss so much that I think I'll keep them this way. I can always...
:o I like that, those are almost a perfect match for each other.
Re: DW-774S/DNA150 + Celestion TF0818 design/build If you got the primer coat real smooth I bet you could get a good shine with just that paint....
Re: DW-774S/DNA150 + Celestion TF0818 design/build I put another coat of black on these today. Here is my painting booth: [IMG] [IMG] I...
Re: DW-774S/DNA150 + Celestion TF0818 design/build I should note that the gun is $22 from menards, I was thinking of the one I was going to get...
Re: DW-774S/DNA150 + Celestion TF0818 design/build I have seen the light! Never again will I use the rattle can for speakers and the roller will...
Re: MTG-06a-OWS Need some copper to finish these, I have a stockpile of caps and resistors but ran dry on most coils. I am also waiting to figure...
Re: MTG-06a-OWS I think I will go with the third order crossover it is only an extra $5 per speaker over the 2nd order and goes down to $4 when...
Re: MTG-06a-OWS Here is the Indoor on wall vs outdoor free space driver measurements: [IMG] Looks like crossover region and above is mostly...
Separate names with a comma.
