Hi Paul, My FRD files are kind of a mess for this design and won't be good to tinker with since they don't really accurately reflect the whole...
Overall length of those ports should be 2". Not in the standard flatpack enclosures, unless you have massive room gain. They are tuned around...
I think I have the original schematic saved here, hope it helps those looking for that. Unfortunately I don't have any of the other photos or...
The problem is that you are only looking at the transfer function when comparing those two drivers and not the SPL or Max SPL graph which are more...
Two 8 ohm drivers in parallel present a 4 ohm load to the amplifier. Both the XLS2502 and NX3000 are rated for a 4 ohm load when in bridged mode.
I'm not sure how difference the frequency response on these would be from a normal lab15 but if they are similar and Eminence's spec sheet is...
I believe the Magnum-12 has the sensitivity (SPL/V) advantage above 100hz but below that range it actually shifts over to these Lab-15 buyouts due...
Something like this will work, but I would recommend leaving the opening of the recessed frame the full square if you can as the smaller round...
I believe the 15" MBM is 29 or 29.5" tall though you could lay them sideways. The only limitation with the 15's is that they won't really dig...
Hi Bob, Are you open to assembling you own enclosure? If so I would take a look at the Flex-12 design which uses the woofer from the 12" MBM in...
A 1" high x 14" wide x 5" deep slot port would work.
It would be extremely tight, the SEOS-15 is 15.5" wide itself. But if you could get everything built/mounted it should still be ok. Is there a...
I do think one of the coaxial designs could work just as well or better then the HTM's for your application. The pattern control of the coaxial...
Sorry I missed your reply, in your case it would probably be beneficial to go with the 1099's for a center channel over the HTM-1010.
The two models are surprisingly close. The HTM-8 does use better drivers with lower distortion. It also uses a more advanced crossover so the...
Yeah the small tapped horn sub is still available.
The newer Volt series uses a customized set of Beta-CX drivers the biggest noticeable difference is the custom black cones that these use. The...
Either will work, just use more of the R6.7 (cover the back/sides/top) or less of the R13 (just the back/bit on the sides).
Thanks for catching that, I did forget to add the text for 0.51 Ohm resistor in the LF R1 position on those diagrams. Adding polyfil to the top...
How wide is the listening area, if only 2-3 seats across a couch or something you might be ok with the HTM-1010. If any wider then that then I...
Separate names with a comma.
