Separate names with a comma.
They are kind of on the dense side but should still be ok.
No, the crossover for the Volt-10 is designed and tuned specifically for the compression driver that it comes with. Using either of those...
The speakers should be close to the sides of the TV for better phantom center. You do want the baffles sitting close to flush with the front of...
Hi Paul, My FRD files are kind of a mess for this design and won't be good to tinker with since they don't really accurately reflect the whole...
Overall length of those ports should be 2". Not in the standard flatpack enclosures, unless you have massive room gain. They are tuned around...
I think I have the original schematic saved here, hope it helps those looking for that. Unfortunately I don't have any of the other photos or...
The problem is that you are only looking at the transfer function when comparing those two drivers and not the SPL or Max SPL graph which are more...
Two 8 ohm drivers in parallel present a 4 ohm load to the amplifier. Both the XLS2502 and NX3000 are rated for a 4 ohm load when in bridged mode.
I'm not sure how difference the frequency response on these would be from a normal lab15 but if they are similar and Eminence's spec sheet is...
I believe the Magnum-12 has the sensitivity (SPL/V) advantage above 100hz but below that range it actually shifts over to these Lab-15 buyouts due...
Something like this will work, but I would recommend leaving the opening of the recessed frame the full square if you can as the smaller round...
I believe the 15" MBM is 29 or 29.5" tall though you could lay them sideways. The only limitation with the 15's is that they won't really dig...
Hi Bob, Are you open to assembling you own enclosure? If so I would take a look at the Flex-12 design which uses the woofer from the 12" MBM in...
A 1" high x 14" wide x 5" deep slot port would work.
It would be extremely tight, the SEOS-15 is 15.5" wide itself. But if you could get everything built/mounted it should still be ok. Is there a...