Separate names with a comma.
If you want to make them bi-amp-able I'd put the tweeter separately from the woofer and midrange since those two driver and the range they cover...
Yeah you have the older style, only earlier this year did they get changed over.
No significant change in overall system impedance (<0.5 Ohms) at the top end with that resistor added. Now the more recent crossovers have had...
No 1599 designed or in the works that I know of. I don't think the buyout 15's are good much above 200-250hz and at that low of a frequency a...
The Volt-6's should work well enough for that application, I'd go with those if they will look better in your space.
Everything is still in flux, I've not actually started the build yet just purchased drivers and taken some preliminary measurements. I'm planning...
Info #3
Info #2
Oh yeah and you can build a pair for less then $200! Expanding the value buster series beyond just the VBSS subwoofer this design started on a...
It should be ok.
Yes you can do that. Or cut the leads to the correct length and use a utility knife (scrape with the blade sideways) to remove the coating which...
Yeah a full width slot port 1" high and 6" long should still work out well there.
You can probably angle the HTM's a bit though it would be hard to use strong toe in without doing something to the wall itself. Maybe pull the...
1 - Distance to the front wall doesn't necessary need to be as close as possible assuming you have a proper false wall or make it full size. I've...
I'm glad you like them so much. I do still have crossover PCBs for these available. Making the cabinet back square instead of angled is no...
Crossover Assembly Example Videos: [MEDIA] [MEDIA]
Glad to hear, hope they serve you well.
It looks like it should be fine like that, the woofer magnet appears like it will be at least a couple inches away which shouldn't cause any...
For the Volt-8/10 you don't want the magnet directly above the one air core that lays flat but the magnets will have minimal impact on the other...
From what pictures I can dig up on those when searching they look far too thin and compressed or matted to be as useful for damping material. If...