Separate names with a comma.
It should be more then 15 degrees above/below without much change to the response or sound; slightly better coverage below then above. If two...
That's interesting. I have the PCB wired normal polarity since that is what the schematic shows in the speedster page on Paul's website but I'd...
Sorry for the late response, yes you can use two screws through the back of the cabinet, just make sure they don't hit the crossover on the...
I agree the Titans would be overkill. If you have the room and don't mind the extra cost I would go for the HTM-12's so you aren't second guessing...
If they are 5-7" away from the wall you can leave the port on the back of the cabinet, it's not a problem until they are closer to the wall then...
Making the TM or MTM wider will affect the baffle step region, which means the response won't be a flat as in the cabinet it was designed for but...
That's all in Erich's hands now, the design work has been done for months and I even built some assembled crossovers for those a while back. Not...
Yeah the Volt-6 should be able to fit in a 6" deep cabinet no problem, it's 4.5" deep overall with the compression driver on the back. The...
A 4uF cap should be placed in parallel with the 18uF cap (or replace it with a 22uF cap). A 10 Ohm resistor placed in parallel with the 6 Ohm...
Assuming the speakers are elevated so that ear level is between the bottom of the waveguide and the top of the woofer you could probably get as...
Technically the latest crossover has only been tested on the WTMW center configuration. The same crossover should work for a vertical WTMW or...
In that case it doesn't really matter which way it is placed.
Yes that configuration will work fine. If all three speakers are going to be placed like that make sure the L/R have the woofers positioned to...
You can add the capacitor if you want, it's really even optional for the Atmos flat pack. It does help extend the bass response a little and...
No issues making a youtube build video. I've added the new updated crossover schematic and parts list. Feel free to make 3D drawings of the...
10w resistors should be fine unless you plan on driving them at high power levels for long periods of time.
The Volt-6 v2 PCB's should be included with the kits, did you not get any?
Does not matter, they should be the same value.
The HTM-8 is 12.5"W x 16.75"H x 8"D. Though it may end up being 7.5" deep if Erich chose to go with 1/2" Baltic Birch for the flat packs on those.
Usually you don't need it when placing them behind an AT screen unless you want the even more relaxed/softer high frequency response.