Separate names with a comma.
It's hard to explain because the frequency response and distortion are really close between the two designs, CD in the 615LX is slightly smoother...
2018 update: TM and MTM designs likely getting revamped over the next few days.
HTM-8 photo added: [IMG]
The Magnum-12 requires very little if any DSP for the smaller higher tuned enclosures. The DSP was only used to boost the bottom end on the low...
This is the only schematic I have from that design: [IMG] If you looks close you will see that the 150uF capacitor is connected across the...
You should use a modeling program like WinISD or hornresp to plot the SPL of the subwoofer driver in question. Depending on the enclosure type...
If your wall was deep enough it would work to do something like that. For fastening the driver/baffles to the wall I would place a few blocks...
If you stack a few baffles on top one another the backside of the woofer will be too closed off inside the short tube that is formed from all the...
The official volt thread has pictures showing the correct component layout on the boards if that's what you are looking for:...
On the low end no, not really much difference between the woofers up to that power level, however the compression driver in the LX version does...
No the screen won't visibly shake/vibrate from the speakers being placed behind it, they just aren't displacing enough air to move the screen. You...
Unless you have the foam already I personally would use the poly, it's likely far less expensive and should be easier to get the correct amount in...
Yeah you can use those foam tiles inside the cabinet if you want. You really only need to line the walls to about 5-8cm thick, you don't want to...
Thanks, Yes I got the 893 board down from 6.75" x 8" to 6" x 7.5". A few of the others are a bit smaller as well though some I just copied the...
I have also designed a small aluminum input panel that allows you to turn any of the Dayton KAB or Sure JAB amplifier boards with bluetooth into a...
Most of these will be offered with the kits in the near future when the PCB's are ordered in bulk but in the mean time I do have custom crossover...
Looks like everything is correct as far as the wiring goes on that PCB.
I want to say they worked well down to 700-1000hz, I can't really remember the exact number and unfortunately I never took screen shots while I...
Yeah it's a basic estimate on what kind of distances you can expect to reach reference levels with an AV receiver that will output 100-150w vs. a...
More detailed build description: For the enclosure using 3/4" thick material, Front and rear baffle: 11.75" x 8" Sides: 11.75" x 8.5" Top/bottom:...