Separate names with a comma.
Yes this could work. You may not need insulation above the ports just some around and behind the woofer, leaving the top open to the ports.
No the ported volt-8 needs a larger volume to work well, at very least 0.35cuft and is better with 0.45-0.7 cuft.
Note I have updated the MTMWW tower crossover to my latest revision, see post #5 for the newest info. Component changes are mostly to the...
Yes, the crossover between the mid and woofers is about 450hz in the center and tower designs, that is too high for side woofer placement without...
Fusion-8 is likely better then this design using a better CD (205 vs 150). The Alpha-8 uses a nicer woofer then the Fusion-8 so I expect that to...
I think it is in the range of 25-30lbs, most use a French Cleat style bracket for wall mounting:...
You could probably get away with an enclosure that is 10" wide x 6" deep x 14" high. You are limited in depth by that of the driver which is...
Nothing really set for a ported Volt-10LX flat pack design yet. Though I can help with a ported box design, any size constraints? You would...
Make it just tall enough to fit the driver, 6-6.5" if you can. It needs very little airspace. Fill the chamber with fiberglass or poly fill and...
Yes you can replace that cap with one of those types. As long as the cap voltage rating is the same or higher it will be just fine.
Dispersion is about 90 degrees. Above 8k does tend to fall off a bit quicker then the rest of the range but I doubt that would be too noticeable...
I have been working on a shallow box for the 14x14 baffle size, 7" deep: [IMG] It is a little undersized but works ok. Placing a 400uF cap in...
Yes that should work fine. Fill box with polyfil, fiberglass or recycled denim. It won't take much but if using polyfil there should be just...
Yep just tighten to snug, no glue. I have never had one come loose.
Both 18 and 16 gauge should fit, however if you are carful you can drill out the holes to accept larger wire. 3/32" should work with up to 12awg...
Matt - Yes you can change the baffle width on the Volt-10 down to 11", it does change some things with where the baffle step comes into play but...
Foam Rubber? If it is the a foam similar to a mattress pad then that should be fine. Not sure I know what you mean about gluing it to the exterior.
You don't want the internal port opening to be right up against the back of the driver as the sound from the backside of the cone can beam right...
For the Volt-10LX I would say 0.3-0.5 pounds per cabinet should be decent. That is a rough estimate, if it seems really loose fitting in there...
You can mix the two designs for surrounds and front presence speakers without issue. For the sealed speakers if using polyfill moderate fill of...