Separate names with a comma.
Rockwool will work just fine.
If there is open area on the columns like you have illustrated that should be plenty of area for the air/sound from the ports to escape without...
The current HT-12's use a new Celestion woofer, I did design an upgraded version of the crossover for the new version but I haven't had any PCBs...
Yeah definitely some cold looking solder joints on that board. I did create a guide with photos to help when assembling the crossovers which has...
So the original way I voiced the speaker was no jumpers, this also gives the flattest frequency response. It's best used like this for floor...
I did not design a PCB for that one yet, but if you are interested I could possibly develop one and have a few made?
The HT-88 is an MTM design using a pair of 16 ohm variants of the Celestion TF0818 from the HT-8. It uses the square SEOS-77 waveguide which has...
I hadn't really considered building an MTM design, though it's not totally out of the question since I have all the parts here. Bamboo cabinets...
If you want adjustable tilt I'd use a pair of 90 degree brackets at the front of the cabinet, screwed down to the cabinet with a bolt on each side...
I would double check these solder joints. The 3.0uF and the 8.2uF capacitors are the only two inline components for the CD, if a solder joint on...
Use the above instructions, so cut to 3" of you have the port on the left. But if you're using a subwoofer and crossing over around 80hz it...
I have two of the bare PCBs left.
Assuming Volt-8 and if using 3/4" material: Back - 10.5" x 10.5" Sides A - 10.5" x 6" Sides B - 9" x 6"
It should be ok assuming you leave plenty of room around the ports.
Yes that one works as a substitute.
I finally remembered to go looking for these today. How many do you need, just one of the Fusion-8 Center PCBs?
I believe the speaker Erich is speaking of is the newly revamped 88-special and these two designs are very different animals. The new...
Are you sure those are HTM-6's? That's certainly not the crossover design for an HTM-6: [ATTACH] That crossover appears to be from a Fusion-8...
Hi Andy, The VBS-6.2 would work in a design like that, I'd even go so far as to say it would match the HTM-12's and HT-8's better then the...
Hi Andy you could use that air core if you really wanted to get those speakers going. It will reduce the output from the woofer by about 0.5dB in...