Separate names with a comma.
I'm glad you like them so much. I do still have crossover PCBs for these available. Making the cabinet back square instead of angled is no...
Crossover Assembly Example Videos: [MEDIA] [MEDIA]
Glad to hear, hope they serve you well.
It looks like it should be fine like that, the woofer magnet appears like it will be at least a couple inches away which shouldn't cause any...
For the Volt-8/10 you don't want the magnet directly above the one air core that lays flat but the magnets will have minimal impact on the other...
From what pictures I can dig up on those when searching they look far too thin and compressed or matted to be as useful for damping material. If...
They are kind of on the dense side but should still be ok.
No, the crossover for the Volt-10 is designed and tuned specifically for the compression driver that it comes with. Using either of those...
The speakers should be close to the sides of the TV for better phantom center. You do want the baffles sitting close to flush with the front of...
Hi Paul, My FRD files are kind of a mess for this design and won't be good to tinker with since they don't really accurately reflect the whole...
Overall length of those ports should be 2". Not in the standard flatpack enclosures, unless you have massive room gain. They are tuned around...
I think I have the original schematic saved here, hope it helps those looking for that. Unfortunately I don't have any of the other photos or...
The problem is that you are only looking at the transfer function when comparing those two drivers and not the SPL or Max SPL graph which are more...
Two 8 ohm drivers in parallel present a 4 ohm load to the amplifier. Both the XLS2502 and NX3000 are rated for a 4 ohm load when in bridged mode.
I'm not sure how difference the frequency response on these would be from a normal lab15 but if they are similar and Eminence's spec sheet is...