Separate names with a comma.
Foam Rubber? If it is the a foam similar to a mattress pad then that should be fine. Not sure I know what you mean about gluing it to the exterior.
You don't want the internal port opening to be right up against the back of the driver as the sound from the backside of the cone can beam right...
For the Volt-10LX I would say 0.3-0.5 pounds per cabinet should be decent. That is a rough estimate, if it seems really loose fitting in there...
You can mix the two designs for surrounds and front presence speakers without issue. For the sealed speakers if using polyfill moderate fill of...
Yes that is correct.
The LO+ and LO- on the board go to the woofer in the Volt-6. LO+ to the woofer + and Lo- to the woofer -. You can use .205" or .250" quick...
The Volt-6's don't have too much baffle step built in, so I would recommend leaving the crossover as is. It was designed with the thought that it...
Yes placing a piece of fiberglass across the back should be done to minimize rear wave reflections within the wall/ceiling cavity. The ceiling...
DATS V2 reading from the sample. Should be all you need to load into something like WinISD (do so in that order), let me know if you need any of...
You could experiment with it, should not be any excursion issues for the woofers if you use a high pass of at least 80hz and are not giving them...
A: None of the above! The problem is that you cannot measure components once they are wired together in the crossover as there are alternate...
Yes I believe that was added to the new boards.
Those look great Bill, you inspired me to build a set of diffusers. Unfortunately I could not use your design due to space constraints from...