Separate names with a comma.
Sorry I missed your question, I never really finished the TMW design as I was rather disappointed in the performance of that one because it...
The PR version does not suffer from any port resonances that the ported version might have but it looses some output near tuning in the same...
There are no issues putting the Volt-6 on its side to fit below a screen. You could change the baffle width if you needed to make is slightly...
They will work IB but it is best if you use a crossover setting of at least 100-120hz to prevent over excursion. You should not be able to hurt...
Yes this could work. You may not need insulation above the ports just some around and behind the woofer, leaving the top open to the ports.
No the ported volt-8 needs a larger volume to work well, at very least 0.35cuft and is better with 0.45-0.7 cuft.
Note I have updated the MTMWW tower crossover to my latest revision, see post #5 for the newest info. Component changes are mostly to the...
Yes, the crossover between the mid and woofers is about 450hz in the center and tower designs, that is too high for side woofer placement without...
Fusion-8 is likely better then this design using a better CD (205 vs 150). The Alpha-8 uses a nicer woofer then the Fusion-8 so I expect that to...
I think it is in the range of 25-30lbs, most use a French Cleat style bracket for wall mounting:...
You could probably get away with an enclosure that is 10" wide x 6" deep x 14" high. You are limited in depth by that of the driver which is...
Nothing really set for a ported Volt-10LX flat pack design yet. Though I can help with a ported box design, any size constraints? You would...
Make it just tall enough to fit the driver, 6-6.5" if you can. It needs very little airspace. Fill the chamber with fiberglass or poly fill and...
Yes you can replace that cap with one of those types. As long as the cap voltage rating is the same or higher it will be just fine.
Dispersion is about 90 degrees. Above 8k does tend to fall off a bit quicker then the rest of the range but I doubt that would be too noticeable...
I have been working on a shallow box for the 14x14 baffle size, 7" deep: [IMG] It is a little undersized but works ok. Placing a 400uF cap in...
Yes that should work fine. Fill box with polyfil, fiberglass or recycled denim. It won't take much but if using polyfil there should be just...
Yep just tighten to snug, no glue. I have never had one come loose.
Both 18 and 16 gauge should fit, however if you are carful you can drill out the holes to accept larger wire. 3/32" should work with up to 12awg...
Matt - Yes you can change the baffle width on the Volt-10 down to 11", it does change some things with where the baffle step comes into play but...