Separate names with a comma.
Yeah these could be considered satellites in a system like that, usually I think of satellites as the little speakers included in HTiB systems....
Hi Marco, the ports are 1.5" high, 3.75" wide and 7.5" deep, converted to metric they roughly 38mm high x 95mm wide x 190mm deep.
That's a nice receiver. That enclosure is pretty big, make sure you use a decent amount of damping material in there to cut down on standing...
Yeah at least with the 2nd order HP and transfer function I was trying to get for a flat FR in the lower midrange. FR and phase are almost...
Video ;D http://youtu.be/RKIcU8kEN_s?list=UUJIlCIaSWDPq1_OxdqgwiOQ
I updated the post on the previous page with more info. http://www.diysoundgroup.com/forum/index.php?topic=345.msg3214#msg3214 Port tuning is...
I'll replace it with real wood veneer at some point which should be far more durable and hopefully look nicer too if I can get it cut nicely in...
Sorry, I meant to reply earlier but I would not had have much of an update to give. These were at the MWAF this year in the Dayton category and...
I have been listening to these again since picking up a DTA-100 from the PE tent sale but realized I had made one more adjustment since posting...
Usually decent results are not achieved by just swapping drivers with the same crossover, the only time this works well is if the drivers have...
Hi Brian, This is a good resource for crossover assembly: https://www.parts-express.com/resources-building-a-crossover Matt
Nice, very clean setup.
Re: Project NEXUS... Yes that and the tweeter does not have enough output to really match up with the two woofers paralleled. It does make...
Re: Project NEXUS... All that info is in the TM/MTM post, Volume should be ~0.3-0.4 cu ft. Baffle is 6.5"W x 15"H.
Re: Project NEXUS... I am not sure if the panel brace will fit unless you run it vertical in the box. The diameter of the port might be too...
Reseved
Re: Project NEXUS... The MTM does have a few advantages over the TM, Using two woofers you get 6dB more output headroom and at the same time...
That's up to Erich, I really like this design especially with the new crossover. The design using the EOS-8 waveguide fits in the same enclosure...
I played around with this crossover some after I learned a few tricks working with the DNA-150, Here is a new crossover using only 6 parts that...
Yeah that should work fine.