Separate names with a comma.
Re: Project NEXUS... ^ thanks Updated posts to include more info.
Re: Project NEXUS... MTMWW tower / WTMMW center design, could also be configured as a WMTMW design Edit: It comes to life at last! This design...
Re: Project NEXUS... WTMW Center Edit: Could also be built as a vertical WTMW sealed or ported [IMG] This 3 way design uses two of the Dayton...
Re: Project NEXUS... TMW 3-way design - Update, no real advantage with this design when compared with the MTM and far less cost effective.
Re: Project NEXUS... (Warning photo heavy, lots of graphs and schematics) TM/MTM designs Update 1/13/17, Enclosure and crossover redesign for...
There is no real limit on how low you can cross the DNA-360, if the levels are low enough you could run it without a crossover at all without...
Timbre matched family of Hi-Fi/HT speakers all based on the same midwoofer (Dayton DS135-8) and tweeter (ND28F-8). These designs came about from...
You could switch them but the result may not be as good as just using the SEOS-12. There is a slight difference in frequency response of the...
Wow, I am off today ;D I have attached a new schematic that will work with the 360/350 which closely matches the 4550 response.
Sorry saw your post then forgot to reply, The 350 should work fairly well, it won't match the final FR of the 360 exactly but it will be close...
I am glad you are doing well Bill, The timing was unfortunate as I had hoped to finally meet you during my stay with Erich but your health is...
The EOS is too deep a waveguide for a dome tweeter, you would want a shallow waveguide like the DW-62S for the best results. Too deep a waveguide...
For medium sized boxes (like this one) and larger I use the ultra touch denim myself. I try to leave plenty of room around the back of the woofer...
Well I see what you mean about the three bolt holes not having very much room to work with. I think the DNA-360 was designed for 2 bolt drivers...
I finally got around to a revamp on this design after some input from Travis and to better match the SEOSR mains for Jake (chopshop). I posted...
The BMS 4550 does have slightly lower distortion then the DNA-360 below 1.5k, but also has slightly more around and above 2k. However the TD12M...
I added the files in a zip folder and attached here.
The online calculators assume a flat frequency response and impedance while the FR and impedance of most loudspeaker drivers are not quite as...
I also suspect the woofer cap. Try disconnecting the cap and 3 ohm resistor at one of the ends and see what happens. If you have a multimeter...
Nope 650hz is the correct number for the woofer xover setting. There is some boost at 1100hz (6dB) which brings the response up before the actual...