Separate names with a comma.
Yes 1050Hz, Not Linkwitz Riley (LR) filters, use Butterworth, BW 18dB/oct is what it will say in the minidsp drop down box for filter settings....
If you want here are active settings that mirror the passive version, Woofer: 3rd order BW @ 1050Hz 1800Hz, 4dB, Q=2 2800Hz, -10dB, Q=2 CD:...
Changing the compression driver would require a redesign of the crossover, you can't just swap them out. I also think you would be hard pressed...
Yeah that looks correct.
Yeah the HF is better in sealed enclosures as its native response will extend down further (lower F3 then the HO in the same enclosure). For a...
I think any of those coils would be fine, the differences in resistance (a few hundredths' of an ohm) are negligible for the intended application.
They should work fine for the HT listening with the solid state amp but I know tube amps can be picky about what the speaker impedance looks like....
Well lets just say you can't measure the difference besides maybe the tighter tolerances of the Mundorf. Whether or not you can hear the...
I can answer a few of those questions. Yes there should be two of those 20uF capacitors, one goes with the woofer circuit and one on the cd....
Here is a slot port version, I changed the depth a little just because I like sub boxes to be a little deeper then they are high. One that shows...
Well I ran into a slight snag with the single 4" port in that I could not get both the woofer and port to fit on the same face. So this revision...
Actually fitting the port tube in there may present an even greater challenge. Too bad that 4cuft ported flat pack won't fit a 15". The 15" RS HF...
Woofer: http://www.parts-express.com/pe/showdetl.cfm?partnumber=295-469 Plate amp:...
Are you looking to build a DIY sub or buy one? Budget? Size limits?
Yeah no need to go with the Sentinel's for surrounds unless you are the type of person that wants to make sure they get all identical speakers and...
The crossover would need to be redone for that one, sensitivity is a little lower and frequency response is different. Box size and tuning would...
Thanks, On that one I start about 120 feet back, I did not have an SPL meter out there but I estimate that at 1m it was hitting peaks of around...
I think they look great, good job!
I forgot to take some impedance measurements of the finished speakers with the WT3 but I have the simulated impedance which should be pretty much...
Whoops ;D Thanks Tux, looks like I was not paying attention while drawing that up Fixed.