Separate names with a comma.
If you are using any kind of modern AVR with room correction or even basic EQ I'd suggest building the WMTMW center if you are set on that design...
Reversing the polarity on the tweeter would normally cause a large hole in the frequency response around the crossover. Unless your woofers were...
Depends on which Nexus design you are comparing it to but in general the HT-8 will be capable of more output and have better imaging then any of...
My driver is much older, 15-190 (I'm guessing it's year and day of manufacture?). I pulled my driver out and tested it a bunch of different ways...
What are the full specs from your DATS measurement? Sometimes the individual values can look like they fluctuate wildly but often the modeled...
HT-8's will blend just as well with the HTM-12 as they do with the HT-12. HT and HTM lines can be used together seamlessly.
Do you have just one row of seating and are you able to angle the speakers? If yes to both then the HT-6 would be an improvement over the Volt-6,...
I don't have the graph added for the HTM-12 v2 but it's in general a little flatter then the original HTM-12 or the HT-12 both in part due to...
There isn't much difference between the HT-8/10 and HTM-8/10, like the HT-12 and HTM-12 the off axis or polar will look largely the same between...
I took a few quick distortion measurements of the Vortex-15. Update these results are not 100% valid - I found the 2nd harmonic distortion...
I'd go for the HT-12 or HTM-12 if you want the best phantom image from the speakers. They have the largest waveguide witch gives them the most...
The internal horn flare and transition to the cone isn't as ideal as a one piece horn/waveguide (like the SEOS) so there is some slight beaming in...
Generally the left and right are built vertical as it takes up less space and gives better horizontal coverage. It's usually less of an issue with...
No, when these were designed I tried to voice them in such a way that makes then suitable for both baffle wall or freestanding/stand mount...
It should be ok, f3 doesn't move much and you will have more output (less gradual rolloff) below 100hz with that larger cabinet.
Well the Titan-818 woofer cabinet seen in the photo is basically a clone of the VBSS cabinet (tuned to 30hz), and it won't be the only cabinet...
Sorry for the late reply. The Vortex-12 could be used in a 0.8-1.2cuft sealed enclosure though the F3 will end up around 100hz. It could liekly...
If your are not using the flat packs you could make the cabinet tall/deeper in the 2.5-4cuft range tuned to 40-45hz if you want even more bass...
HT-10>Volt-10 in nearly all aspects except vertical dispersion which makes the Volt-10 better for use a atmos speakers.
For atmos I would use the MT design as it will have better vertical dispersion then the MTM. That said If you only have one row of seating or...