Separate names with a comma.
I tried not getting into full baffle step, it's really closer to 4dB above 150hz but the close coupling of the woofers to the floor slowly...
Enclosure sizing is on post #2. Ideal sealed volume is around 1 cuft, beyond that you don't really gain much in terms of flatness or extension.
This would work. You don't port an IB back into the room like a ported enclosure if that is what you are asking, but it is ok if it is open to...
If the enclosure is built from 1/2" material you could get it down to 12"H x 8"W x 5.75" deep external, using included 3/4" baffle. They will...
This design works well at the current crossover point, both drivers are not pushed beyond what I consider safe or undesirable. Yes the BA750 with...
You might find the flat pack to be optimal in you situation. The measurement I took was outdoors up on a high stand (4pi), this provides useful...
Sorry file is quite large >150MB, won't go over email so well. If I get a chance I'll upload it to a file sharing site.
If you ordered the kit with the stock baffle you can just build the box 6.5" deep which will maintain the volume of the angled enclosure, but it...
This design was done for NWCgrad over on AVS forum. He inquired about using the beefier PSD2013-8 compression driver on the back of the...
No problem Rajdeep, it was nice to have someone stop by for a listen. Ryan, just let me know if you will be visiting the Chicago area at any...
I would recommend the volts for this, the coaxial design will give you even coverage no matter which direction you are from the speaker. The...
No I suppose not. It will work sealed if you were to use a 120hz crossover, in that case you could get away with a 0.1-0.2cuft enclosure. The...
Hi Bryan, The woofer will work sealed between 2-4cuft (F3 right about 80hz), it could be as simple as cutting the bottom portion with the port...
Those are internal enclosure volumes.
Really looking good. I don't think that gap is too bad, I had a similar sized gap around the waveguide on my enclosures for the MTG-08 design and...
Yes though you may be able to use the DNA-360 settings from the PM you will get in a few minutes that have the JBL 2226H crossover. The TD15M...
I don't know if there is anything that would be a drop in substitute, the Celestion CDX1-1010 might work with some minor adjustments to the...
I'd say you can start with those then adjust EQ on the CD so that the response is flatter with the SEOS-15 and you may need to adjust delay on the...
What kind of design, active or passive? What if I were to say both already exist :eek: [IMG] [ATTACH] [ATTACH]
Re: Fusion-15 Assembely Info and Tips Thread reserved