Separate names with a comma.
Usually decent results are not achieved by just swapping drivers with the same crossover, the only time this works well is if the drivers have...
Hi Brian, This is a good resource for crossover assembly: https://www.parts-express.com/resources-building-a-crossover Matt
Nice, very clean setup.
Re: Project NEXUS... Yes that and the tweeter does not have enough output to really match up with the two woofers paralleled. It does make...
Re: Project NEXUS... All that info is in the TM/MTM post, Volume should be ~0.3-0.4 cu ft. Baffle is 6.5"W x 15"H.
Re: Project NEXUS... I am not sure if the panel brace will fit unless you run it vertical in the box. The diameter of the port might be too...
Reseved
Re: Project NEXUS... The MTM does have a few advantages over the TM, Using two woofers you get 6dB more output headroom and at the same time...
That's up to Erich, I really like this design especially with the new crossover. The design using the EOS-8 waveguide fits in the same enclosure...
I played around with this crossover some after I learned a few tricks working with the DNA-150, Here is a new crossover using only 6 parts that...
Yeah that should work fine.
Re: Project NEXUS... ^ thanks Updated posts to include more info.
Re: Project NEXUS... MTMWW tower / WTMMW center design, could also be configured as a WMTMW design Edit: It comes to life at last! This design...
Re: Project NEXUS... WTMW Center Edit: Could also be built as a vertical WTMW sealed or ported [IMG] This 3 way design uses two of the Dayton...
Re: Project NEXUS... TMW 3-way design - Update, no real advantage with this design when compared with the MTM and far less cost effective.
Re: Project NEXUS... (Warning photo heavy, lots of graphs and schematics) TM/MTM designs Update 1/13/17, Enclosure and crossover redesign for...
There is no real limit on how low you can cross the DNA-360, if the levels are low enough you could run it without a crossover at all without...
Timbre matched family of Hi-Fi/HT speakers all based on the same midwoofer (Dayton DS135-8) and tweeter (ND28F-8). These designs came about from...
You could switch them but the result may not be as good as just using the SEOS-12. There is a slight difference in frequency response of the...
Wow, I am off today ;D I have attached a new schematic that will work with the 360/350 which closely matches the 4550 response.