Separate names with a comma.
I do have some crossover boards available, I have 2 of the Tower/Center PCBs and 4 of the MT/MTM PCBs left. I can ship them overseas though it...
The solder joints really just have to conduct electricity and provide a secure connection, getting the ideal amount of solder on there for a...
If you want to make them bi-amp-able I'd put the tweeter separately from the woofer and midrange since those two driver and the range they cover...
Yeah you have the older style, only earlier this year did they get changed over.
No significant change in overall system impedance (<0.5 Ohms) at the top end with that resistor added. Now the more recent crossovers have had...
No 1599 designed or in the works that I know of. I don't think the buyout 15's are good much above 200-250hz and at that low of a frequency a...
The Volt-6's should work well enough for that application, I'd go with those if they will look better in your space.
Everything is still in flux, I've not actually started the build yet just purchased drivers and taken some preliminary measurements. I'm planning...
Info #3
Info #2
Oh yeah and you can build a pair for less then $200! Expanding the value buster series beyond just the VBSS subwoofer this design started on a...
It should be ok.
Yes you can do that. Or cut the leads to the correct length and use a utility knife (scrape with the blade sideways) to remove the coating which...
Yeah a full width slot port 1" high and 6" long should still work out well there.
You can probably angle the HTM's a bit though it would be hard to use strong toe in without doing something to the wall itself. Maybe pull the...