Separate names with a comma.
Yeah the tuning came in much lower then expected, even for the Vortex-12 I had to make the ports about half as long as I initially modeled as the...
Rockwool will work just fine.
If there is open area on the columns like you have illustrated that should be plenty of area for the air/sound from the ports to escape without...
The current HT-12's use a new Celestion woofer, I did design an upgraded version of the crossover for the new version but I haven't had any PCBs...
Yeah definitely some cold looking solder joints on that board. I did create a guide with photos to help when assembling the crossovers which has...
So the original way I voiced the speaker was no jumpers, this also gives the flattest frequency response. It's best used like this for floor...
I did not design a PCB for that one yet, but if you are interested I could possibly develop one and have a few made?
The HT-88 is an MTM design using a pair of 16 ohm variants of the Celestion TF0818 from the HT-8. It uses the square SEOS-77 waveguide which has...
I hadn't really considered building an MTM design, though it's not totally out of the question since I have all the parts here. Bamboo cabinets...
If you want adjustable tilt I'd use a pair of 90 degree brackets at the front of the cabinet, screwed down to the cabinet with a bolt on each side...
I would double check these solder joints. The 3.0uF and the 8.2uF capacitors are the only two inline components for the CD, if a solder joint on...
Use the above instructions, so cut to 3" of you have the port on the left. But if you're using a subwoofer and crossing over around 80hz it...
I have two of the bare PCBs left.
Assuming Volt-8 and if using 3/4" material: Back - 10.5" x 10.5" Sides A - 10.5" x 6" Sides B - 9" x 6"
It should be ok assuming you leave plenty of room around the ports.
Yes that one works as a substitute.
I finally remembered to go looking for these today. How many do you need, just one of the Fusion-8 Center PCBs?
I believe the speaker Erich is speaking of is the newly revamped 88-special and these two designs are very different animals. The new...
Are you sure those are HTM-6's? That's certainly not the crossover design for an HTM-6: [ATTACH] That crossover appears to be from a Fusion-8...
Hi Andy, The VBS-6.2 would work in a design like that, I'd even go so far as to say it would match the HTM-12's and HT-8's better then the...