Separate names with a comma.
Yes placing a piece of fiberglass across the back should be done to minimize rear wave reflections within the wall/ceiling cavity. The ceiling...
DATS V2 reading from the sample. Should be all you need to load into something like WinISD (do so in that order), let me know if you need any of...
You could experiment with it, should not be any excursion issues for the woofers if you use a high pass of at least 80hz and are not giving them...
A: None of the above! The problem is that you cannot measure components once they are wired together in the crossover as there are alternate...
Yes I believe that was added to the new boards.
Those look great Bill, you inspired me to build a set of diffusers. Unfortunately I could not use your design due to space constraints from...
I missed your post earlier, it has been a busy week for me, are you still in the area for this weekend? I may be able to host you for a demo on...
That is sort an open ended option. There is no real plan for building them into a ceiling because every situation may be different. The easiest...
I made a quick video showing how to assemble a crossover for any of the DIYSG kits that include a PCB. [MEDIA] I may update this post and add...
It may have to be slightly shorter, the thinner you make the port or rather the higher the aspect ratio the more surface drag from the walls of...
Actually that picture is of the CA154, the original woofer that was going to be used for this design. If you looks close you can see the surround...
I recently grabbed a bunch of inexpensive 1.75" VC 1" exit compression drivers to test. Thought I would post some frequency response sweeps on...
You want the cross sectional area of the port to be roughly 32 sq in (inch or two either way does not matter much) and 5" long. So for a 16"...
That the maximum excursion limited output of a single driver at the low frequencies, shows how as tuning goes lower you loose some output above...
It should be alright but I would recommend some thick damping material be placed across the box somewhere in the midsection to help reduce...
I've added mounting depth for the all the volt drivers to post #3. The volt-10 is 6" deep with the dna-150 attached so you will need at least...
Yep, that's correct.
Unfortunately the crossover is not likely to work as well with the Beta-12CX, you could try but the delays from the physical offset, frequency...
I am not sure if it comes cut or not. Besides the waveguide and CD do not take up very much internal volume, you would be looking at a change of...
I tried not getting into full baffle step, it's really closer to 4dB above 150hz but the close coupling of the woofers to the floor slowly...