Separate names with a comma.
A 1" high x 14" wide x 5" deep slot port would work.
It would be extremely tight, the SEOS-15 is 15.5" wide itself. But if you could get everything built/mounted it should still be ok. Is there a...
I do think one of the coaxial designs could work just as well or better then the HTM's for your application. The pattern control of the coaxial...
Sorry I missed your reply, in your case it would probably be beneficial to go with the 1099's for a center channel over the HTM-1010.
The two models are surprisingly close. The HTM-8 does use better drivers with lower distortion. It also uses a more advanced crossover so the...
Yeah the small tapped horn sub is still available.
The newer Volt series uses a customized set of Beta-CX drivers the biggest noticeable difference is the custom black cones that these use. The...
Either will work, just use more of the R6.7 (cover the back/sides/top) or less of the R13 (just the back/bit on the sides).
Thanks for catching that, I did forget to add the text for 0.51 Ohm resistor in the LF R1 position on those diagrams. Adding polyfil to the top...
How wide is the listening area, if only 2-3 seats across a couch or something you might be ok with the HTM-1010. If any wider then that then I...
Updated the list to show what's still available.
I recommend 3/4" MDF for the enclosures which will be more solid unless you used 1/2" and added more bracing. Increasing the size of the sealed...
Yes keep the port at full length. I don't have many good images showing how I put the damping in these cabinets but the guide by Troels is a good...
The enclosure for the TM design is tuned to about 60hz. These ports should work for the TM design if they are easier to get:...
It does not matter which way the leads are run, there is no polarity to the inductors. When I am installing coils like that I usually position...
This might help then: [ATTACH]
Did you miss the crossover schematic for those on post #6? That shows how the crossover components are wired up. Otherwise if you bought the...
The on axis HTM-10 and HTM-12 measurements are in a baffle wall, the HTM-6 is not. BSC begins around 200hz for the HTM-10 and HTM-12.
You can build the TM design sealed in a small 0.08-0.1cuft enclosure. However the woofer will rolloff around 100hz when used sealed. You could...
When it comes to powering subwoofers headroom and volume are the only two benefits to more power assuming the subwoofer driver in question can...