Separate names with a comma.
DanO, did you lose one of your PCB's? Was it the 2.1 or 2.2 version?
The standard 1446 will not work because the custom version used in the Volts has a different ohm rating. The crossover design will not work...
All of those solder joints should be reheated to let the solder flow better on the round silver pads. Also be sure that you're soldering to the...
Volt-8 kits will likely be in stock at the end of the week. The issue has been crossover parts and ports. All of the circuit boards were...
Vince, couldn't you just leave the tweeter at the top and aim it down a bit?
Waiting on ports for the HT-8 and HT-88. Waiting on front baffles for the HT-12. HT-10 will probably be in stock next week.
That's seems quite high. I would double check everything and rerun your calibration.
I have some replacement 15" woofers available.
There will be more 1299's up on the site next week. I'm waiting on more baffles for those. HT-12's will be in stock next week. If you're...
The Hyperlite is a lot different than the Deltalite and would not work. Send me an email and I can get you a replacement. If you already have...
As for making more Vortex kits, it would probably require some type of group buy. When they were at their original price, pretty much none sold....
You're freaking people out on the 1099's. :) They aren't going anywhere. The 10" woofers you see in the Closeout section are B-stock...
The Vortex-15's were clearanced out last year divided in 2 runs of orders. Those are pretty much gone for good. As for the other kits,...
I've been putting a decent number of kits in stock as parts come in but they don't seem to last very long. Overnight Sensations are in stock....
I'm waiting on woofers and compression drivers for the Volt-10 and not sure how long it will be before they're back up on the site. I ordered...
They've been done for a while, I just haven't posted them on the site yet.
Multiple subs would be best. If you're getting the Titans you could get your subwoofers/flat packs from the same place. :)
Crossover parts list and circuit board layout are in post #2.
While waiting for the concrete company to raise that back corner slab I worked on this opposite wall to get it done. Pressure washed, primed,...
I do have crossover parts for the HTM-12, HT-12, some HT-8's, S2000 MT and MTM's, and some 1099's. MTG-90 sent me some assembled crossovers for...